User Manual

5200WHC2 Wiser Home Controller 2 Installation Instructions

Installation

The Wiser Home Controller 2 must be programmed by a competent installer before the

control and monitoring functions are available!

Download the Required Software Tools

The software applications for Wiser 2 (C-Bus Toolkit, Zoolkit and PICED) from Schneider

Electric can be freely downloaded from the Clipsal. com CIS portal:

http://www.clipsal.com/CIS

Select Technical and then navigate to Downloads

Each of the software products that you download from the CIS web site has its own setup

ﬁle. The setup ﬁle is self-extracting and includes an installation wizard. It is recommended

that you SAVE the downloaded ﬁle to your hard drive in a folder that is easy to access.

Normally, the default location for program ﬁles will work, but you can specify another

location.

PICED Conﬁguration Software from Schnieder Electric is required for all Wiser 2

Installations. PICED is the tool that sets up the following:

• Locating the Wiser 2 on the network and setting the IP address.

• The monitoring and control functions for all included devices.

• Graphical User Interface (GUI) for local and remote communication.

• User proﬁles that control visibility and access to devices.

The steps needed to conﬁgure the Wiser 2 with PICED vary depending on the types of

devices that are connected to the system. Schneider Electric provides software tools to set

up the Wiser 2. Your installation might not require all of the tools mentioned below:

Will you be conﬁguring ZigBee

devices?

ZigBee Use Zoolkit (ZigBee Conﬁguration Software) from Schneider Electric to

collect information about your existing ZigBee network.

Using (1) a PC, (2) a UZI / EZI Zigbee adapter and (3) Zoolkit software,

you can map the ZigBee network before or after connecting the Wiser 2.

Refer to the instructions provided with the ZigBee adapter and Zoolkit

Help ﬁles.

Will you be conﬁguring C-Bus devices?

C-Bus

Use C-Bus Toolkit software from Schneider Electric to map the existing

C-Bus network.

If you are not using C-Bus, you can install the Wiser 2 by de-selecting

C-Bus features during programming in PICED. Later, if you add a

C-Bus network, you will use Toolkit to assist you.