Specifications

Conduit Entry
975-0581-01-01 2–3
This manual is for use by qualified personnel only
Conduit Entry
Conduit and cable entry is from the underside of the unit. Figure 2-1 shows a top
view of the maximum allowable area and location in which electrical conduits
may penetrate the enclosures of the Xantrex inverter. Conductor size must be
pre-determined when the conduit is installed.
If your configuration doesn’t allow for conduit installation as described, contact
your local representative or customer service for other installation options which
may be approved for your configuration.
1000 Vdc Option Pre-installation
If you have a Xantrex GT630 E with 1000 Vdc input option, you need to install the
resistor assembly in the sub-floor of the concrete PV box or pad. You must
contact Schneider Electric for detailed instructions on installing the resistor for
your specific installation.
Figure 2-1 Enclosure Conduit Entries, Viewed from Top
83 440
605
83 500 500 83
83 440
6051205
83
440
605
188
153
291
452
CABLE ENTRY DC+
CABLE ENTRY DC-
CABLE ENTRY COMBINER DC
CABLE ENTRY AC
CABLE
SECURING RAIL
RUBBER CABLE
CLAMP STRIPS
CONDUIT ENTRYCONDUIT ENTRY
FRONT
+H0 +H1 +H2
All measurements in mm