Installation manual
Table Of Contents
- Xantrex™ GT100 E 100 kW Grid-Tied Photovoltaic Inverter
- Xantrex GT100 E 100 kW Grid-Tied Photovoltaic Inverter
- Copyright and Contact
- About This Manual
- Important Safety Instructions
- Contents
- Figures
- Tables
- Introduction
- Planning
- Installation
- Verification and Commissioning
- Specifications
- Commissioning Test Record
Operator Interface Controls
152364 1–3
This manual is for use by qualified personnel only.
Operator Interface Controls
The Xantrex GT100 E inverter enclosure is IP21 rated and contains the power
electronic inverter bridge, electrical and electromechanical control components,
power supplies, system sensing circuits, converter control unit 2 (CCU2), the AC
and DC disconnects and the isolation transformer
Operator interface controls are located on the front door of the inverter enclosure.
These controls include an
ON/OFF switch, and a front panel user interface,
comprised of a 4-line display and keypad. Additionally there is an AC disconnect
and an emergency (E-STOP) push button.
WARNING: Shock hazard
Turning the ON/OFF switch to the
OFF
position does not remove all hazardous
voltages from inside the inverter. Before attempting to service the Xantrex GT100 E
,
follow the de-energize Lockout and Tag procedure on page xi.
Figure 1-1 Xantrex GT100 E Operator Interface Components
AC Disconnect
Switch
Front Panel
User Interface
ON/OFF Switch
Emergency Stop
Switch
Ventilation
(Inlet)
Ventilation
(Outlet)
Ventilation
(Inlet)