Installation manual
Table Of Contents
- Xantrex™ GT100 E 100 kW Grid-Tied Photovoltaic Inverter
- Xantrex GT100 E 100 kW Grid-Tied Photovoltaic Inverter
- Copyright and Contact
- About This Manual
- Important Safety Instructions
- Contents
- Figures
- Tables
- Introduction
- Planning
- Installation
- Verification and Commissioning
- Specifications
- Commissioning Test Record
Introduction
1–6 152364
This manual is for use by qualified personnel only.
AC Disconnect Switch
The AC disconnect switch is the primary disconnect for the inverter. The
inverter’s doors cannot be opened until the AC disconnect switch is in the OFF
position. The AC disconnect switch interrupts the AC voltage supply to the
inverter. Once the switch is open there is still voltage on the grid side of the
switch. There is also DC voltage on the DC input terminal block and the input of
the DC contactors.
To operate the inverter the AC switch must be in the ON position.
The Xantrex GT100 E inverter enclosure doors must be locked during normal
operation.
WARNING: Shock hazard
Disengaging the inverter enclosure door interlock switch does not remove all
hazardous voltages from inside the inverter. Before attempting to service the
Xantrex GT100 E, follow the de-energize Lockout and Tag procedure on page xi.
Figure 1-4 AC Disconnect Switch
AC Disconnect
Switch