Installation manual
Table Of Contents
- Xantrex™ GT100 E 100 kW Grid-Tied Photovoltaic Inverter
- Xantrex GT100 E 100 kW Grid-Tied Photovoltaic Inverter
- Copyright and Contact
- About This Manual
- Important Safety Instructions
- Contents
- Figures
- Tables
- Introduction
- Planning
- Installation
- Verification and Commissioning
- Specifications
- Commissioning Test Record
Installation
3–4 152364
This manual is for use by qualified personnel only.
To move the enclosure using the lifting eyebolts:
1. Place the lifting straps onto the eyebolts as shown in Figure 3-3.
All four-corner eyebolts must be evenly loaded.
2. Strap the unit such that the angle between the sling and the cabinet top is
greater than 60 degrees.
3. Remove the pallet from underneath the unit
Figure 3-3 Eyebolt Lifting Locations - From Above Unit