Installation manual
Table Of Contents
- Xantrex™ GT100 E 100 kW Grid-Tied Photovoltaic Inverter
- Xantrex GT100 E 100 kW Grid-Tied Photovoltaic Inverter
- Copyright and Contact
- About This Manual
- Important Safety Instructions
- Contents
- Figures
- Tables
- Introduction
- Planning
- Installation
- Verification and Commissioning
- Specifications
- Commissioning Test Record
Mounting and Anchoring the Units
152364 3–5
This manual is for use by qualified personnel only.
Mounting and Anchoring the Units
To mount and anchor the Xantrex GT100 E:
1. Predrill the floor or pad to accept masonry anchors for 12 mm bolts, or
ensure it has pre-installed anchoring bolts that will fit the 18 mm mounting
holes. See Figure 2-3 on page 2–7.
2. Lift the Xantrex GT100 E from beneath with a forklift or pallet jack as shown in
Figure 3-2 on page 3–3, or lift the Xantrex GT100 E from above as shown in
Figure 3-3 on page 3–4. Move the inverter enclosure into place.
3. Secure the inverter enclosure feet to the floor with the appropriate anchoring
hardware.
Figure 3-4 Mounting Locations
Mounting Hole