Installation manual

Commissioning Test Record
152364 B–3
This manual is for use by qualified personnel only.
Commissioning Test Record
Step 1. Record and Document Serial Number and Inverter Location
Date and Time of Commissioning:
Inverter Serial Number: Technician Name:
CCU2 Board Serial Number: Company Name:
Inverter Location: Bldg. # Contact Email:
Address: City: State:
Step 2. Installation and Cable Check
Power Conductors installed correctly: Yes
 Terminations are properly torqued: Yes 
Step 3. Verify AC Utility Voltage at CB1
A-B Measurement: B-C Measurement:
C-A Measurement: Phase Rotation: CW
Step 4. Verify DC PV Voltage at PV Contactor - K2
Pos - Neg Measurement: _________Vdc.
DC Polarity is correct: Yes

Step 5. Apply AC Grid Voltage to the Xantrex GT100 E
Control Power circuits energized: Yes

Notes:
Step 6. Confirm Operation of Universal Frontpanel Control Unit
User Interface Boots and Displays correctly: Yes 
Software version (CCU2 SW): Software version (UFCU SW):
Notes:
Step 7. Confirm Write Menu Parameters for AC Limits
Max AC Volts %: Min AC Volts %:
Max AC Frequency: Min AC Frequency:
Max GND Fault:
Notes:
Step 8. Confirm Write Menu Parameters for PV Settings
PV V Start: PV T Start:
PV P Stop: PV T Stop:
Notes:
Step 9. Confirm Write Menu Parameters for Power Tracker Configuration
PPT V Ref: I PPT Max %:
PPT Enable: PPT Rate:
PPT V Rate:
Notes:
Step 10. Operate the Xantrex GT100 E in Power Tracking Mode
I PPT Max% initially set to10 %: Yes
 I PPT Max % gradually increased to 100 %: Yes 
Xantrex GT100 E operates correctly: Yes 
Notes: