Installation manual

Installation
3–2 153396 Revision D
This manual is for use by qualified installers only
Unloading
Moving the Xantrex GT250
To move the Xantrex GT250, use a forklift that has a sufficient lift capacity and
has a 66 cm (26 inch) fork span or a crane with a minimum lift capacity of
2500 kg (5512 lbs).
To move the Xantrex GT250 by forklift:
1. Place the forks of the forklift below the shipping pallet at the points specified.
2. Pay attention to the balance point (center of gravity) of the Xantrex GT250.
3. Lift the enclosure from beneath the shipping pallet.
Unpacking the Xantrex GT250
To unpack the Xantrex GT250:
1. Remove the plastic wrapping material surrounding the Xantrex GT250.
2. Remove and save the front and rear enclosure skirts.
3. Remove the Xantrex GT250 anchor hardware that attaches to the shipping
pallet.
WARNING: Heavy Equipment
The Xantrex GT250 weighs approximately 2018 kg (4055 lb). Attempting to lift the
equipment by other than the recommended lifting points may damage the
equipment or present a personnel safety hazard and void the warranty. Keep all
the doors closed and latched when moving the enclosures. Leaving the door
latches unsecured may result in damage to the unit and void the warranty.
WARNING: Crush Hazard
If lifted incorrectly, the Xantrex GT250 could fall over and cause personal injury.
c
CAUTION: Equipment Damage
To move the Xantrex GT250 by forklift, use a forklift that has a sufficient lift
capacity and has a 66 cm (26 inch) fork span. Failure to use a forklift of this size
and capacity can result in damage to the unit and may void the warranty.