Installation manual

Unloading
153396 Revision D 3–3
This manual is for use by qualified installers only
Removing the Pallet and Moving the Xantrex GT250
Use Figure 3-1 to locate the balance point or center of gravity ( symbol).
Moving with a Forklift
To move the Xantrex GT250 using a forklift:
1. Place the forks of the forklift below the unit at the points specified in
Figure 3-2 on page 3–4.
2. Lift the Xantrex GT250 from beneath.
3. Remove the shipping pallet from beneath the unit.
4. Once the shipping pallet is removed from the unit, use the same lifting
locations to lift the unit into the place where it may be permanently located.
c
CAUTION: Equipment Damage
To move the Xantrex GT250, use a forklift that has a sufficient lift capacity and a
66 cm (26 inch) fork span.
Figure 3-1 Center of Gravity
Important: Be sure to use a forklift with a 66 cm (26 inch) fork span.
Center of Gravity
Side viewFront view
 
1143mm (45")
700mm (27.5")
330mm (13")