Installation manual

Unloading
153396 Revision D 3–5
This manual is for use by qualified installers only
Removing the Air Intake Duct
The Air Intake Duct may be removed from the rear of the Xantrex GT250
enclosure if it is necessary to move the inverter through a standard 36-inch door
opening and into location.
To remove the Xantrex GT250 air intake duct:
1. Remove and save the 8 mm nuts (14 total) that attach the air intake duct to
the rear of the Xantrex GT250 enclosure.
2. Carefully remove the air intake duct.
3. Once the Xantrex GT250 is moved and installed, replace the air intake duct,
and tighten the 8 mm nuts (14 total).
Figure 3-4 Removing the Air Intake Duct
Important: Before proceeding with the installation, determine the location and
layout of the components, conduit penetration locations, conductor and conduit
sizing, and method for anchoring the unit. Ensure adequate space is provided
for clearance for ventilation and serviceability. Review Chapter 2, “Planning” if
necessary before proceeding.
Air Intake Duct
8 mm nuts (14 total)