Installation manual

Index
975-0601-01-01 Revision B IX–3
This manual is for use by qualified personnel only.
I
IEEE (Institute of Electrical and Electronics
Engineers) v
IGBT (insulated gate bipolar transistor) v
inspection for commissioning 4–3
installation
AC (auxiliary power) wiring 3–24
AC barrier, re-installing 4–7
AC barrier, removing 3–23
AC wiring
connecting 3–23
anchoring 2–7
anchoring bolt pattern 2–8
auxiliary power wiring 3–24
bottom entry 2–6
cable entry 2–4
center of graviy, inverter assembly 3–5
center of graviy, transformer assembly 3–6
chassis ground 3–21
clearance requirements 2–2
conductor requirements 2–4
conduit entry 2–4
conduit requirements 2–4
DC barrier, re-installing 4–8
DC barrier, removing 3–25
DC terminal polarity 3–26
DC wiring 3–25
grounding (chassis) 3–21
grounding bar 3–22
grounding requirements 2–4
high ambient temperature conditions 2–3
inverter assembly 3–11
maximum ambient temperature 2–3
Modbus 3–26
moving 3–2
moving with forklift 3–7
moving with sling, inverter assembly 3–8
moving with sling, transformer assembly 3–9
PV planning 2–2
re-installing AC barrier 4–7
re-installing DC barrier 4–8
removing AC barrier 3–23
removing DC barrier 3–25
side entry 2–4, 2–5
throat connection kit 3–12
transformer assembly 3–11
unpacking 3–3, 3–4
ventilation requirements 2–3
wiring, AC 3–23
wiring, AC (auxiliary power) 3–24
wiring, auxiliary power 3–24
wiring, DC 3–25
wiring, DC terminal polarity 3–26
Institute of Electrical and Electronics Engineers
(IEEE) v
insulated gate bipolar transistor (IGBT) v
interface, operator controls 1–11
inverter assembly
center of gravity 3–5
closing the doors 3–17
DC interface 1–7
definition iv
heaters 1–8
installation 3–11
opening the doors 3–17
power electronics 1–8
isolation transformer 3, 2–4
K
keypad
verification during commissioning 4–10
L
limitations on use viii
lock-out and tag-out procedure xi
logging, data 1–15
M
maximum ambient temperature 2–3
Modbus 3–26, 4–13
Modbus addresses, configuring 4–14
monitoring, remote 1–9
mounting instructions 3–11
moving the unit
center of gravity
inverter assembly 3–5
transformer assembly 3–6
forklift 3–7
overview 3–2
sling
inverter assembly 3–8
transformer assembly 3–9
N
naming conventions iv
National Fire Protection Association (NFPA) v
NFPA (National Fire Protection Association) v
NOTICE, definition v