Installation manual

Unloading and Moving the Xantrex GT500
975-0601-01-01 Revision B 3–9
This manual is for use by qualified personnel only.
Moving the Transformer Assembly with a Sling
Figure 3-6 Moving with a sling: inverter assembly
WARNING
HAZARD OF CRUSH INJURY
• Verify that the capacity of the handling equipment is adequate for the
transformer assembly’s weight (see Table A-1 on page A–2).
• Keep all unnecessary personnel away while handling and moving the
assemblies.
Failure to follow these instructions can result in death or serious injury.
Pin locations on
base frame
Use a spreader bar
to help prevent
damage to the
inverter assembly.
Use slings rated
appropriately for the
inverter assembly’s
weight.