Manual

37
Diagnostics
English
W916556680111
Diagnostics during Ethernet addressing
PROBLEM/
MESSAGE
CAUSE SOLUTION
When you send the
ARP –S command, the
message "The ARP entry
addition failed: 5” is
displayed.
You have opened a
session with an ID that
does not give you the user
rights for this command on
this PC.
Open a new session with the
required user rights.
You are trying to assign
an IP address to the
splitter box using the ARP
method, but the error
message “Press Enter to
go into Setup Mode” is
displayed. When you try
again to connect to the
unit by Telnet, you are
disconnected.
When connecting by
Telnet to port 1 of the
splitter box, the
IP address you are giving
is temporary. When
connecting by Telnet to
port 9999, you must press
the Enter key quickly
otherwise the unit restarts,
which causes the
IP address to be lost.
Set up a new connection by
Telnet on port 1. Wait until the
connection fails, then set up a
new connection by Telnet on port
9999, and make sure you press
Enter quickly.
When you connect by
Telnet on port 9999, the
message “Press Enter to
go into Setup Mode” is
displayed, but nothing
happens when you press
the Enter key, or the
connection is broken.
You have not pressed the
Enter key quickly enough.
You have only 3 seconds
to press Enter before
disconnection.
Set up a new connection by
Telnet on port 9999, but press
the Enter key as soon as the
message “Press Enter to go into
Setup Mode” is displayed.