Schneider Electric XW-MPPT-60 User Manual

975-0400-01-01 Revision H iii
This manual is for use by qualified personnel only.
About This Guide
Purpose
The purpose of this Guide is to provide
explanations and procedures for installing,
configuring, operating, and troubleshooting the Conext MPPT Solar Charge Controller
(solar charge controller).
Scope
This Guide provides safety guidelines, detailed planning and setup information,
procedures for installing the unit, as well as information about operating and
troubleshooting the unit. It does not provide details about particular brands of
photovoltaic (PV) panels. You need to consult individual PV manufacturers for this
information.
Audience
This Guide does not provide sufficient information for anyone but a qualified
installer to install this product. Installers should be electricians or technicians fully
educated on the hazards of installing electrical equipment. The monitoring and
operation information in this manual is intended for anyone who needs to operate
the solar charge controller.
Organization
This Guide is organized into five chapters and four appendices.
Chapter 1 describes features and functions of the Conext MPPT Solar Charge
Controller.
Chapter 2 contains information and procedures to install the Conext MPPT Solar
Charge Controller.
Chapter 3 contains information and procedures to configure the Conext MPPT
Solar Charge Controller.
Chapter 4 contains information about the operation of the Conext MPPT Solar
Charge Controller.
Chapter 5 contains information about identifying and resolving possible problems
with systems using a Conext MPPT Solar Charge Controller.
Appendix A provides the specifications for the Conext MPPT Solar Charge
Controller.
Appendix B is a guide to the Conext System Control Panel monitoring and
configuration menus for the Conext Solar Charge Controller.
Appendix C provides information on boost charging for flooded lead-acid batteries
in off-grid applications.
975-0400-01-01_Rev-H(XW-MPPT60-150).book Page iii Thursday, November 23, 2017 11:48 AM