Schneider Electric Owner's Guide

Conext System Control Panel Menus

B–4 975-0560-01-01 G

Changing Settings Using the SCP

To change a charge controller’s setting, use the buttons on the SCP to perform

three basic steps:

1. View the Select Device menu.

2. Select the charge controller from the Select Device menu.

3. Select and adjust a changeable setting on the charge controller’s Setup

menu. See page B–8.

Each of these three steps is described in detail in the following sections.

Table B-2 Screen and menu descriptions

Screen or menu Description

Startup screen Appears for a few seconds after the system starts up or when the system has been

reset.

System Status

screen

Displays status information for the power system, consisting of all Xanbus-

connected devices on a single network. The System Status home screen

appearance varies with the status of the Conext XW+ Inverter/Charger and other

Xanbus-enabled devices in the power system. The System Status home screen

features a menu arrow pointing to the Enter button. Pressing Enter takes you to the

Select Device menu.

XW MPPT Home

screen

Displays status information for the charge controller.

Select Device

Displays a list of Xanbus-enabled devices in the system, including the charge

controller and the SCP. The length of this menu depends on how many Xanbus-

enabled devices are installed in the system. This menu also contains the clock

menu (where you can set the time and date) and the system settings menu (where

you can change system modes). The System Panel, Clock, and System

Settings menu items are available from the Select Device menu, regardless

of the number of Xanbus-enabled devices installed.

XW MPPT Setup

Displays status information and changeable settings. Changeable settings are

identified by square brackets [ ] around values in the right-hand column.

NOTE

You can also view the charge controller’s Setup menu by pressing Enter from

the charge controller’s home screen. See “Home Screen” on page B–10.

975-0560-01-01(XW-MPPT80-600_Ops).book Page 4 Wednesday, November 22, 2017 5:52 PM