Schneider Electric Owner's Guide

Configuration Settings
975-0560-01-01 G B–7
Configuration Settings
The configuration settings can be viewed in basic and advanced formats.
Basic menu The basic menu contains items you might have to view and adjust on a routine
basis.
Advanced menu The advanced menu contains items intended for service personnel and one-time
setup, such as auxiliary output and custom battery configuration. To display the
Advanced Settings menu item instead of the Basic Settings menu item,
perform the following special keypress::
◆ From the Setup menu, press the Enter, up arrow, and down arrow buttons
simultaneously.
On the Setup menu, Basic Settings disappears from the bottom of the
list, and Advanced Settings appears at the top of the list.
After configuring the charge controller, help prevent unintended advanced
configuration by using the combined keypress again to hide the advanced menu
items.
The charge controller Config menu contains sub-menus for configuring:
• Multiple-unit operation
• Charger and battery settings
• Input settings
• Auxiliary output settings.
To view the Config menu:
◆ From the Setup menu, with Basic Settings or Advanced Settings
highlighted, press Enter.
NOTE
• This keypress displays advanced settings for every device in the system.
• After performing the keypress, Advanced Settings appears at the top of
the Setup menu. When the keypress is performed again, the Setup menu
displays Basic Settings as the last item on the menu.
Figure B-5 Selecting the configure menu
XW MPPT80 01: Config
[MPPT80 02]
XW MPPT80 01: Setup
Advanced Settings
[Disabled]
[Operating]
975-0560-01-01(XW-MPPT80-600_Ops).book Page 7 Wednesday, November 22, 2017 5:52 PM