Schneider Electric Owner's Guide

Conext System Control Panel Menus
B–8 975-0560-01-01 G
For a map of all configuration menus, see Figure B-7 on page B–9.
Configurable settings are identified by square brackets [ ] around the values
along the right side of the screen.
To select and change a configurable setting:
1. On the menu, press the up arrow or down arrow button to highlight the
setting you want to change.
2. Press Enter to highlight the current value of the setting.
3. Press the up arrow or the down arrow button to change the value. Hold down
the button to scroll through a large range of values quickly.
The previously set value appears with an asterisk (*) beside it.
4. Press Enter to select the value.
To restore the charge controller’s default settings:
1. On the Config menu, select Restore Defaults.
2. Press Enter.
Figure B-6 Configuration menus (Basic)
XW MPPT80 01: Config
XW MPPT80 01: Dev Info
[Flooded]
[440Ah]
[100%]
[3Stage]
[48.0V]
XW MPPT80 01: Setup
[Disabled]
[Operating]
XW MPPT80 01: Meters
215W
2.1A 100.5V
210W
3.7A 57.4V
0:00:00
3.5Ah 0.20kWh
0.1kAh 5kWh
20C
Float
ManualOff
Off
Basic Settings
975-0560-01-01(XW-MPPT80-600_Ops).book Page 8 Wednesday, November 22, 2017 5:52 PM