Conext Automatic Generator Start Installation

Introduction
1–6 975-0307-01-01
Bottom Panel
Network Port Each network port can accept an eight-pin RJ45 plug attached to a
Category 5 (CAT 5) Xantrex Xanbus network cable. Depending on the
installation, both ports may be required.
20-contact
Connector
The 20-contact connector supports a wiring harness (included) that
connects the Xantrex XW AGS to a generator and thermostats. The
wiring harness also provides lines for connecting external generator
shutdown sensors or switches and external generator ON/OFF controls.
Figure 1-3 Xantrex XW AGS Bottom Panel
CAUTION:
Connect only to Class
2 ELV circuits.
Refer to manual.
!
Network
Generator
Xantrex Xanbus
Network Ports
20-contact Generator
Connector Port
CAUTION: Equipment Damage
Connect the Xantrex XW AGS only to other Xantrex Xanbus compatible
devices.
Although the cabling and connectors used in this network system are the
same as those used for Ethernet, this network is not an Ethernet system.
Equipment damage may result from attempting to connect these two
different systems.
Figure 1-4 Wiring Harness