Conext Automatic Generator Start Installation

Troubleshooting
5–2 975-0307-01-01
Faults and Warnings
Under certain conditions, the Xantrex XW AGS generates a fault or
warning message. These messages appear on the Xantrex XW System
Control Panel.
Acknowledging
messages
When a fault or warning message appears, it will remain on the screen
until it is acknowledged by pressing Enter on the Xantrex XW System
Control Panel. This action removes the message from the screen, but
does not clear the condition that caused the fault or warning.
Consult Table 5-25 and Table 5-26 for recommendations for resolving the
fault after it has been acknowledged.
Warnings that are in the form of a Yes/No question can be acknowledged
by pressing Enter for Yes and Exit for No.
Self-clearing
warnings
If unacknowledged, some warnings may clear themselves if the
condition that generated the message goes away. For example, if the
Xantrex XW AGS fails to start the generator, warning message W202
appears. However, if the generator starts on the next start try, the
message goes away.
Clearing faults To clear active Xantrex XW AGS faults, highlight Clear Faults on the
Xantrex XW AGS menu and press Enter.
Multiple faults
and warnings
If several fault or warning messages occur before they can be
acknowledged or cleared, they are displayed together on a fault list or a
warning list. These lists contain messages from every Xantrex Xanbus-
enabled device, not just the Xantrex XW AGS. Message details can be
selected and viewed from the fault list or warning list.
To view a message from a fault list or warning list:
1. On the list, use the arrow buttons to highlight the message to be
viewed.
2. Press Enter.
The complete message appears.
To return to the fault list or warning list, press Exit.
To continue to the menu for the device that caused the fault or warning
condition by pressing Exit.
Each time you return to the list after viewing a complete message, the
viewed message is removed from the list.