Conext XW PRO 6848 6,800W 48V Installation

Resetting the Conext XW Pro to DefaultSettings
WARNING
ADVANCED CONFIGURATION HAZARD
n Advanced menu settings should be used by qualified personnel only.
n Three phase operation should be configured by qualified personnel only.
n Consult with the local utility before enabling Conext XW Pro sell mode or grid support
functions.
n Do not change these settings unless you are under the supervision and direction of
qualified personnel.
n Connect the Conext Gateway and the network router connected to the Conext Gateway
to an assured power source during configuration.
Failure to follow these instructions can result in death, serious injury, or equipment
damage.
The Reset to Factory command returns the Conext XW Pro to factory default
settings. After using the Reset to Factory command, the Conext XW Pro is no
longer configured for the power system.
NOTICE
RESTORING DEFAULTS
Do not restore defaults while the Conext XW Pro is operating. De-energize the power
system and disconnect the Conext XW Pro AC input before restoring defaults. Reconfigure
the Conext XW Pro before reconnecting the AC input and re-energizing the powersystem.
Failure to follow these instructions can result in equipment damage.
To restore the Conext XW Pro default settings, on the Controls Setup menu in the
Advanced view, select Reset to Factory for the Reset control.
Conext XW Pro Owner's Guide Configuration
100 This document is intended for use by qualified personnel 990-91227A-01