Conext XW PRO 6848 6,800W 48V Installation

Setting the Device Name
The Dev Name setting allows you to customize the name of the Conext XW Pro as it is
displayed on other screens and menus.
The characters available are:
n A to Z
n a to z
n 0 to 9
n space
NOTE: Increasing the number of characters in a device name may cause other text on
the same line to run off the edge of the screen. Device names should be limited to 10
characters or less.
The Conext XW Pro device name can be set at the device’s Configuration page in
the Conext Gateway web application under the Device Instance menu.
NOTE: It is also possible to change the device name using the Conext Configuration
Tool. Please refer to the Owner’s Guides for the Conext Configuration Tool for further
information.
Setting the Device Number
When several devices of the same type are installed in the Xanbus network, setting the
device number is required to give a Xanbus-enabled device a unique identity. When each
identical device has a unique number, the Conext Gateway web application can correctly
identify and display status information for each device. Adevice number consists of two
digits ranging from 0 (default) to 247.
If only one of each type of device is installed in the networked power system, a device
number is not needed. However, setting the device number to a value other than 0 is
recommended in case you need to use the Restore Defaults command. This
command resets the device number to 0. After performing the command, checking that
the device number has returned to 0 indicates that the command was successfully
completed. The Device Number can be set at the device’s Configuration page in
the Conext Gateway web application under Device Instance.
Configuration Conext XW Pro Owner's Guide
990-91227A-01 This document is intended for use by qualified personnel 53