Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
n IEEE 1547.1-2005
n IEEE 1547a-2014 (Amd 1)
n California Rule 21
n Hawaiian Electric Company (HECO)
n Puerto Rico Energy Power Authority (PREPA)
Grid Support Utility Interactive Functions
These Grid Support Utility Interactive Functions are included in the Conext XW Pro
inverter:
n Anti-Islanding
n Voltage Ride-Through (L/HVRT) and disconnection
n Frequency Ride-Through (L/HFRT) and disconnection
l Available for HECO settings and modified Molokai and Lanai ride through and
disconnect settings as well.
n Volt-Var Q(V)
n Soft Start (SS)
n Ramp Rate (RR)
n Fixed Power Factor (FPF)
n Frequency-Watt P(f)
n Volt-Watt P(V)
n TROV
n Voltage and Frequency Reconnection
Conext XW Pro Installation Guide Specifications
115 This manual is intended for use by qualified personnel 990-91228A-01