Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Explosive Gas Precautions
WARNING
EXPLOSION HAZARD
The Conext XW Pro is not ignition protected. To prevent fire or explosion, do not install this
product in locations that require ignition-protected equipment. This includes any space
containing gasoline-powered machinery, fuel tanks, as well as joints, fittings, or other
connections between components of the fuel system.
Failure to follow these instructions can result in death, serious injury, or equipment
damage.
Working in the vicinity of lead acid batteries is dangerous. Batteries generate explosive
gases during normal operation. Therefore, you must read this Installation Guide and
follow the instructions exactly before installing or using your inverter/charger.
To reduce the risk of battery explosion, follow these instructions and those published by
the battery manufacturer and the manufacturer of the equipment in which the battery is
installed.
Conext XW Pro Installation Guide Product Safety Information
11 This manual is intended for use by qualified personnel 990-91228A-01