Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Converting Split-phase to Single-phase
Converting Split-phase to Single-phase Conext XW Pro Installation Guide
8
Converting 120 V/240 V Split-phase to 120 V Single-phase 123
Installation Tools and Materials 124
Disconnecting Power Sources 124
AC Access Panel Removal 125
Reconfiguring the Secondary Transformer Wires on X1 and X2 Connectors 127
Reconfiguring the AC Ports on the Load, AC1, and AC2 Connectors 129
Upgrading the Firmware 130
Updating the Label 131
What's in This Chapter?