Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Note: To complete the conversion, you must refer to firmware upgrade instructions in
the Conext Gateway Owner's Guide (975-0806-01-01) available from
http://solar.schneider-electric.com.
Note: To set up a three-phase system using three 120V-configured Conext XW Pro
units, perform the conversion procedure for all three Conext XW Pros.
Installation Tools and Materials
To complete the conversion, you will need the following:
n a Phillips #2 screwdriver
n one small jumper and three large jumpers, included with the Conext XW Pro, see
Figure 69 .
Figure 69 Conext XW Pro Jumpers
Disconnecting Power Sources
To disconnect power sources:
1. Put the Conext XW Pro system in Standby mode (for more information about standby
mode, see the Owner’s Guide), disconnect AC sources (such as the utility grid and
generators) by turning off the AC input breakers, and disconnect DC sources (for
example, batteries) by turning off the DCbreaker.
2. Turn off and disconnect all AC loads by turning off the AC output breaker.
Converting Split-phase to Single-phase Conext XW Pro Installation Guide
990-91228A-01 This manual is intended for use by qualified personnel 124