Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Upgrading the Firmware
To upgrade the firmware, refer to instructions in the Conext Gateway Owner's Guide
(975-0806-01-01). If you do not have this guide, download it from http://solar.schneider-
electric.com.
To upgrade the firmware:
1. Download the latest firmware for your Conext XW Pro Inverter/Charger from
http://solar.schneider-electric.com and save it onto your computer.
2. Using your computer's web browser, navigate to the Conext Gateway's web
application, log in, and go to the applicable device page.
3. In the Firmware page, follow the on-screen instructions.
4. Record the new firmware version for future reference.
Converting Split-phase to Single-phase Conext XW Pro Installation Guide
990-91228A-01 This manual is intended for use by qualified personnel 130