Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Updating the Label
On the inverter/charger, mark the box on the bottom of the label beside “
OPTIONAL CONFIGURATION, 120 V, 2 WIRE” to indicate the inverter has been converted.
Figure 75 Updated Label
Conext XW Pro Installation Guide Converting Split-phase to Single-phase
131 This manual is intended for use by qualified personnel 990-91228A-01