Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Overview
The Conext XW Pro is a modular building block sine-wave inverter/charger that can be
used for residential and commercial battery based off-grid, grid backup, and grid
interactive applications.
The Conext XW Pro is a self-contained DC to AC inverter, battery charger, and
integrated AC transfer switch. It is configurable in a hybrid system to operate with
generators and renewable energy sources. These configurations are capable of
extending battery based off-grid/backup autonomy.
Note: The Conext XW Pro inverter/chargers are designed for operation with single
phase, three wire (120V/240V) AC sources and should not be connected to a three-
phase AC source.
Inside the Box
Conext XW Pro and System Components
The following system components are included in this package. If any items are missing,
contact your authorized dealer.
Figure 1 System Components
Battery Temperature Sensor
The Battery Temperature Sensor (BTS) included in this package monitors the
temperature of the battery bank and adjusts the charging accordingly. For installation
instructions, see"Installing the Battery Temperature Sensor" on page51.
Conext XW Pro Installation Guide Introduction
17 This manual is intended for use by qualified personnel 990-91228A-01