Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Conext XW Jumpers (For Single-Phase Conversion)
Conext XW Jumpers are used to reconfigure a standard unit 120V/240V, three-wire, split-
phase model to accept a 120 V, 2-wire, single-phase connection. Use the jumpers to
reconfigure the transformer wires. For more information, see "Converting 120 V/240 V
Split-phase to 120 V Single-phase" on page123.
Conext XW Pro Features
Figure 2 Features
Optional Accessories
The following optional accessories are available for the Conext XW Pro inverter/charger.
For an up-to-date list, call an authorized dealer or visit
https://solar.schneider-electric.com.
Conduit Box
Part Number 865-1025-01
Introduction Conext XW Pro Installation Guide
990-91228A-01 This manual is intended for use by qualified personnel 18