Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test โ Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
The Conduit Box provides an enclosure over the bottom of the Conext XW Pro and
covers the cabling that runs underneath.
For installation instructions, see Installing the XW Conduit Box on page 34.
Figure 3 ๎Conduit Box
Note: Your installation may require the inclusion of the Conduit Box, depending on
local electrical code. Consult your local electrical authority to ensure your installation is
code-compliant.
Power Distribution Panel (PDP)
Part Number 865-1015-01
The Power Distribution Panel (PDP) is factory wired and labeled with everything to
support a single-inverter installation.
Internal wiring and breakers can be added to expand the Conext XW Pro with up to three
inverters, four charge controllers, or other equipment to support 120/240๎volt, three-wire,
single-phase systems.
The PDP interfaces๎with the following Conext products:
n XW Pro 6848 NA inverter/charger
n Conext MPPT solar charge controllers (breakers and wiring not included)
The Conext XW Pro Power Distribution Panel includes the components shown below.
Conext XW Pro Installation Guide Introduction
19 This manual is intended for use by qualified personnel 990-91228A-01