Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Conext Automatic Generator Start (AGS)
Part Number 865-1060-01
The Conext AGS can automatically start and stop a generator, providing your Conext
XW Pro Inverter/Charger with power to recharge depleted batteries while powering your
loads. The AGS adds intelligence to power management and minimizes time spent
monitoring batteries and inverter loads.
For more information, see the Conext Automatic Generator Start Owner’s Guide.
Figure 7 Conext AGS
Conext Gateway
Part Number 865-0329
The Conext Gateway is a multi-function communication device that provides an overall
view of system performance for residential power monitoring systems. It also provides a
communications gateway between a network of Xanbus™-enabled devices and Modbus
devices.
For more information, see the Conext Gateway Owner’s Guide.
Figure 8 Conext Gateway
Conext Battery Monitor
Part Number 865-1080-01
The Battery Monitor is Xanbus-enabled, and features a local display to selectively show
the estimated operating voltage, current, consumed amp-hours, remaining capacity and
remaining hours in your 48 V battery bank.
For more information, see the Conext Battery Monitor Quick Start Guide.
Introduction Conext XW Pro Installation Guide
990-91228A-01 This manual is intended for use by qualified personnel 22