Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Knockout Selection
Note: Do not drill, cut, or punch holes into the Conext XW Pro, Conduit Box or Power
Distribution Panel (PDP). Use only the knockouts provided for conduit entry.
The Conext XW Pro, Power Distribution Panel (PDP), and Conduit Box are equipped
with nested dual knockouts for wiring through conduits.
Read "Removing the AC Access Panel and PDP Internal Faceplates" on page44 and
choose the knockouts for your installation.
See below, for an example of available knockouts along the top and side of the Power
Distribution Panel (PDP).
Figure 11 Example of available knockouts on the PDP
Remove your choice of knockouts from the Conext XW Pro chassis, Conduit Box,
and/or Power Distribution Panel (PDP). Verify that no debris remains inside the chassis.
Insert appropriately-sized conduit bushings into each conduit hole.
Pre-Installation Planning Conext XW Pro Installation Guide
990-91228A-01 This manual is intended for use by qualified personnel 28