Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Air Filter and AUX Port Connector Installation
Insert the air filter by tucking it into the grooves on the sides of the air vent cover, see
Figure 12 .
If you are planning to use the auxiliary (AUX) port features, insert the AUX port connector
into the AUX portr, see Figure 12 .
For more information, see AUX Port on page 47 of this Guide.
Figure 12 Air Filter and AUX Port Connector Installation
Conext XW Pro Installation Guide Pre-Installation Planning
29 This manual is intended for use by qualified personnel 990-91228A-01