Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Figure 14Mounting plate centered on wall studs
Installation tip
If you install the bottom of the mounting plate at 60" from floor, the inverter information
panel will be approximately 65" from the floor.
4. Install additional mounting plates adjacent to each other as needed.
Note: The mounting plates are designed to interlock, as shown in the figure below, so
that multiple plates can be installed without additional measuring or leveling.
Figure 15 Two interlocking mounting plates
Wall-Mounting the Conext XW Pro and PDP
To wall-mount the Conext XW Pro Inverter/Charger:
1. Align the flange on the back of the Conext XW Pro chassis with the bottom edge of
the mounting plate, as shown in Figure 16 .
Pre-Installation Planning Conext XW Pro Installation Guide
990-91228A-01 This manual is intended for use by qualified personnel 32