Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Figure 16 Wall-mounting the Conext XW Pro
WARNING
HEAVY EQUIPMENT
The Conext XW Pro weighs approximately 120 lbs. A two-person lift is required. To prevent
personal injury, always use proper lifting techniques during installation.
Failure to follow these instructions can result in death, serious injury, or equipment
damage.
2. Lower the Conext XW Pro chassis flange onto the mounting plate.
3. Secure the bracket at the top of the Conext XW Pro chassis with two #10 self-tapping
screws (included).
4. Wall-mount the PDP and any additional Conext XW Pros using this same procedure.
Installation tip
The PDP is designed to mount on the right side of the inverter/charger, but it can be
configured to mount on the left side instead. For more information, see the Power
Distribution Panel (PDP) Installation Guide.
Conext XW Pro Installation Guide Pre-Installation Planning
33 This manual is intended for use by qualified personnel 990-91228A-01