Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Label Symbols
NOTE: The term "ground" is equivalent to "earth", and the use of these terms depends on
local codes and standards. This document uses the term "ground" throughout.
The following symbols appear on labels on or in the inverter.
Hazardous voltage
Hot surface
2
Stored energy hazard discharge time
Refer to the Installation or Operation
instructions
Protective (grounding) conductor terminal
Direct current
Alternating current