Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Wiring the Power Distribution Panel (PDP) to a Generator (On-Grid)
In an on-grid installation, the generator will require an additional 60 A, 120/240 VAC, two-
pole, type QOU AC breaker to be installed in the Power Distribution Panel (PDP).
Figure 33 Wiring the Conext XW Pro Power Distribution Panel to a Generator (On-Grid)
Conext XW Pro Installation Guide Wiring
63 This manual is intended for use by qualified personnel 990-91228A-01