Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Figure 37 Disabled Mode
To enable the inverter:
n On the inverter information panel, simultaneously press the STARTUP/SHUTDOWN
button and the Equalize button. The Conext XW Pro is now enabled, and En (enabled)
is briefly displayed on the inverter information panel, as shown in Figure 38 .
Figure 38 Enabled Mode
To disable the inverter:
1. On the inverter information panel, simultaneously press the STARTUP/SHUTDOWN
button and the Equalize button. The Conext XW Pro is now disabled, and diS
(disabled) is briefly displayed on the inverter information panel, followed by "---" (as
shown in Figure 39 ).
Wiring Conext XW Pro Installation Guide
990-91228A-01 This manual is intended for use by qualified personnel 70