Conext XW PRO 6848 6,800W 48V Manual
Table Of Contents
- Safety Information
- Label Symbols
- Radio Frequency Interference Notices
- Audience
- About
- Product Safety Information
- Introduction
- Pre-Installation Planning
- Wiring
- Removing the AC Access Panel and PDP Internal Faceplates
- Communication Ports and BTS Port
- Wiring the Conext XW Pro with a PDP
- Basic Functional Test – Single Inverter
- Wiring Additional Conext XW Pro units with a PDP
- Basic Functional Test - Multiple Inverters
- Wiring the Conext XW Pro Inverter/Charger without a PDP
- Communication
- Access Installation
- Specifications
- Wiring Diagrams
- Converting Split-phase to Single-phase
Figure 48 Triple-Inverter AC Breaker Arrangement with a Single AC Input Source
Figure 49 Triple-Inverter AC Breaker Arrangement with Two AC Input Sources
Installing an External Bypass Switch
Note: The Conext Power Distribution Panel (PDP) does not have enough breaker
locations to accommodate bypass breakers in more than three inverter systems.
Therefore, an external bypass switch may be needed. For an illustration of an External
Bypass Switch installation, see Figure 50 on page 87.
Wiring Conext XW Pro Installation Guide
990-91228A-01 This manual is intended for use by qualified personnel 86