Conext XW PRO 6848 6,800W 48V Manual

DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, ARC FLASH, AND FIRE
n Battery Circuit Breakers must be installed according to the specifications and
requirements defined by Schneider Electric.
n Servicing of batteries must only be performed by qualified personnel knowledgeable of
batteries and the required precautions. Keep unqualified personnel away from
batteries.
n Disconnect the charging source prior to connecting or disconnecting battery terminals.
Failure to follow these instructions will result in death or serious injury.
This section provides illustrations for wiring the AC and DC connections for a Conext
XW Prowithout a Power Distribution Panel (PDP).
Pre-Installation Steps
Depending on your installation, you will need to perform some or all of some the following
pre-installation steps:
1. Prepare the battery bank. See "Battery Bank Preparation" on page37.
2. Wall-mount the Conext XW Pros. See Wall-Mounting the Conext XW Pro and PDP
on page 32.
3. Install Conduit Boxes as needed. See Installing the XW Conduit Box on page 34.
4. Install AC sync and Xanbus cable(s) as needed. SeeSee "Installing AC sync and
Xanbus cables" on page102.
5. Remove knockouts on the PDP as needed to accommodate the wiring. See
"Knockout Selection" on page28 for more information about knockouts.
Feed-in Protection Requirements
NOTICE
OVERLOADING THE DISTRIBUTION PANEL
The amount of power that can be fed into a distribution panel and the means and location
for feed-in, must be in accordance with NEC 2017 article 690.64 or the current
requirements of the local electrical code.
Failure to follow these instructions can result in equipment damage.
Wiring Conext XW Pro Installation Guide
990-91228A-01 This manual is intended for use by qualified personnel 90