User Manual

10
Easy UPS SRV Series Extended Runtime 1000VA, 2 000VA, 3000VA
UPS Power On/Off button
 Press this button to turn on the UPS.
 Press and hold this button until a beep is heard to turn off the
UPS.
 Press this button to reset alarms.
Status LED
The Status LED illuminates green when the power is on. This
LED indicates two different states of output power:
 Output off : LED blinks. Press Power On/Off button to
turn the output power on.
 Output on : LED illuminates green continuously.
LCD Display
The display interface options are visible on this LCD screen. Press
the o r button to activate LCD, if the display
is not illuminated.
Mute/Esc button
 To acknowledge audible alarms and suppress them
temporarily.
 To exit a sub menu and return to the main menu.
Enter button
Press this button to enter the menu or to select a menu item/ value
during navigation.
Up / Down button
Press these two buttons to scroll through the main menu options and
display screens.
Alarm LED
This Alarm LED illuminates red when the UPS detects an error and
blinks red for UPS notifications. See “ Alarms and Notifications”
on page 11 in this manual.
LCD Display Icons
On Line: The UPS is drawing utility power and performing double conversion to supply
power to the connected equipment.
On Battery: The UPS is supplying battery backup power to the connected equipment.
Replace Battery: The battery is not connected securely or the battery is nearing the end of
its service life and should be replaced.
Bypass : The UPS is in bypass mode, sending utility power directly to connected equipment.
Bypass mode operation is the result of an internal UPS event or an overload condition.
Battery operation is not available while the UPS is in bypass mode. See “Alarms and
Notifications” on page 11 in this manual. This icon in combination with Green Mode icon,
indicates that the UPS is in green mode operation.
ALARM
System Alarms: An internal fault is detected. See “Alarms and Notifications” on page 11
in this manual.
Overload: The equipment connected to the UPS is drawing more power than rated.
Battery Charge: The battery charge level is indicated by the number of bar sections
illuminated. When all five blocks are illuminated, the battery is fully charged. Each bar
represents approximately 20% of the battery charge capacity.
Load Level: The load percentage is indicated by the number of load bar sections
illuminated. Each bar represents approximately 20% of the maximum load capacity.
Mute: An illuminated line through the icon indicates that the audible alarm is disabled.