User Manual

8
Easy UPS SRV Series Extended Runtime 1000VA, 2 000VA, 3000VA
Start Up Settings
Connect the battery
Connect UPS to the external battery pack with a battery cable. Refer to
right chart for external battery connection.
 Please connect the battery according to the battery voltage indicated on
the rear panel. If the connected battery voltage is incorrect, UPS may be
damaged and cannot be repaired. Therefore, be sure to confirm that the
battery voltage is in accordance with the UPS specification.
Connect power and equipment to the UPS
CAUTION
HAZARD OF ELECTRIC SHOCK
•
All electrical work must be performed by a qualified electrician.
•
Turn off all power to this equipment before working on the equipment. Practice lockout/tagout procedures.
•
Do not wear jewelry when working with electrical equipment.
Failure to follow these instructions can result in minor or moderate injury.
1. Connect equipment to the UPS. Avoid using extension cords.
2. Connect input utility power to the UPS.
3. Switch on the input utility power. Then, the UPS display panel will illuminate when utility power is available.
Start the UPS
Press the button located on the front panel of the UPS.
 Do not expect full battery run capability during this initial charge period.
Cold start the UPS
Use cold start feature to supply power to connected equipment from the UPS batteries.
Press the button. Then, the display panel will illuminate. Press the button again to supply
battery power to the connected equipment.