Instructions

PHA7630205 Rev.00
Caloundra Range Sweep Fan
Installation Instructions
C4HS1300-WE
C4HS1300-AN
C4HS1300L-WE
For your safety
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION
OR ARC FLASH
• This product must only be installed by
appropriately qualified and/or licensed electrical
personnel.
• Isolate the electrical supply before doing any
work on this product.
• Ensure that the product has been correctly
installed and tested for safe operation before
reconnecting the electrical supply.
Failure to follow these instructions will result
in death or serious injury.
CAUTION
IMPORTANT INSTALLATION SAFEGUARDS
• The mounting bracket must be fixed to a solid
structure, such as a ceiling joist, and this must
be capable of supporting a weight of 30kg.
• The fan should be mounted so that the blades
are at least 2.1m above the floor, and 300mm
from the tip of the blade to the nearest object or
walls. (Figure 1).
• The fan hanging system supports a maximum
18-degree angled ceiling installation (Figure 2).
Failure to follow these instructions can result
in injury, equipment damage or unnecessary
vibration and noise.
CAUTION
IMPORTANT CLEANING SAFEGUARDS
• Isolate the electrical supply before doing any
cleaning of this product.
• Periodic cleaning of your ceiling fan is the only
maintenance required.
• Use a soft brush or lint free cloth to avoid
scratching the paint finish.
• Do not use water when cleaning your ceiling fan
as it could damage the motor or blades and
create the possibility of an electric shock.
• The motor has a permanently lubricated ball-
bearing so there is no need to oil.
Failure to follow these instructions can result
in injury or equipment damage.
FIGURE 1.
FIGURE 2.
Installation Procedure
STEP 1: PRE-INSTALL CHECK
Prior to installation, carefully identify the parts
(Figure 3).
1. Mounting bracket x1
2. Pre-assembled fan motor, downrod, canopy and
bottom cover x1
3. Blades x4
4. C2000 Wall Switch x 1
5. Balancing Kit x1
6. Blade Screws x9
7. Wooden Screws for mounting bracket x2
FIGURE 3.
FIGURE 3.
STEP 2: WIRING TO THE BRACKET TERMINALS
• See following page for Electrical Wiring Diagram
(Figure 8.)
STEP 3: INSTALLING THE MOUNTING BRACKET
• Secure the mounting bracket to the ceiling joist
or structure with the two long screws provided
(Figure 4).
• Ensure at least 30mm of the screws is threaded
into the support.
• The bracket screws provided are for use with
wooden structures only. For structures other
than wood the appropriate screw type must be
used.
FIGURE 4.
STEP 4: INSTALLING THE BLADES
• Insert the blade into the square slot of the motor
(Figure 5.).
• Secure the blade on the bracket by using the two
motor screws, ensuring they are tightened
simultaneously.
• Once completed, repeat the process on the
remaining blades.
FIGURE 5.
STEP 5: HANGING THE FAN
• Lift the fan assembly onto the mounting bracket.
• Ensure the registration slot of the hanger ball is
positioned on the stopper of the mounting
bracket to prevent the fan from rotating when in
operation (Figure 6.)
FIGURE 6.
STEP 6: FINISHING THE INSTALLATION
• As the electrical connection was completed in
Step 2, connect the ceiling fan to the terminal by
connecting the quick-connector plug.
• Cover the mounting bracket with the canopy.
Ensure all electrical wiring is tucked inside the
canopy and that the wires are not damaged
during this step.
• Secure the canopy to the mounting bracket
using the screws provided (Figure 7.)
FIGURE 7.
Max.18°