Installation Guide

1-4 975-0691-01-01 Revision B

6. BTS (Battery Temperature Sensor) Port

7. Battery Analog Signal Port

8. Xanbus Ports

Functions

The Battery Monitor features six data monitoring functions including:

• Voltage (Battery voltage)

• Amps (Real-time charge/discharge current)

• Amp-Hours (Amount consumed. Displayed after Function F2.0 - Nominal

battery capacity is set)

• State-of-charge (Percent of capacity)

• Time Remaining (Time remaining until a battery recharge is necessary)

• Temperature (Battery temperature if BTS is installed, otherwise displays

temperature setting)

• Mid Point Sensing

Alarms

The Battery Monitor features two alarms including:

• Low voltage indicator (shown by Lo on LCD display)

• Full charge indicator (shown by Full on LCD display)

Buzzer

The Battery Monitor has an internal buzzer which alerts the user. The buzzer will

beep for the following reasons:

When the Reset button is held, the buzzer will beep once per second to indicate

the amount of time required to perform the two different reset types.

• To perform a basic reset while retaining all settings, press and hold the

reset button until you hear 3 beeps, then release the button.

• To perform a full reset and simultaneously reset all settings to factory

defaults, press and hold the button until you hear 5 beeps, then release

the button.

The buzzer will also beep twice after a firmware update has been installed with

the Conext ComBox or Conext Configuration Tool.

MAIN

Fvll