Installation Guide

3-38 975-0691-01-01 Revision B
SCP Menu Map
The Conext System Control Panel (SCP) provides remote configuration and
monitoring capability for the Battery Monitor and other Xanbus-enabled devices
in the network. Below is a map of Battery Monitor menu functions.
Note: All data in Figure 3-8 is sample data and may not necessarily correspond
with the data on your system.
Note: If more than one Battery Monitor is present in a system and DC
associations are given default names, the names on other devices could be
[Faster]
Conext BM 00 : Adv
Peukert Expo [1.25V]
Charge Eff [Auto]
Temp Coeff
Sync Sensitivity
[0.5%]
[3]
Time Rem Filter
Multi Unit Config
Restore Defaults
Conext BM 00 : Basic
Capacity [450Ah]
Discharge Rate [20h]
Shunt Amps [500A]
Shunt mV [50mV]
Self Disch [3.0%]
Discharge Floor [50%]
Float Volt [52.8V]
Float Amps [2%]
Temp Unit [Celsius]
Nominal Temp [25øC]
Back Light Timer [30]
Auto Sync Time [240]
Advanced Settings
Basic Settings
Mode [Standby]
Battery Temp
28øC
Time Remaining
03:56 h:m
AH Removed
-150Ah
State of Charge
75%
Battery
31.7A
57.4V
RS485 Settings
Synchronize Now (control button)
Mid Points 23.8V23.7V
Conext BM 00: RS485 Sett
Address [001]
Baud Rate [119200]
Parity [Even]
Stop Bits [One]
Byte Order [LSB]
Conext BM 00 : Multi
Dev Name
Dev Number
DC Conn
Conext BM 00 : Meters
[BM1]
[00]
[HouseBatt1]
Conext System Control Panel
Battery Monitor Menu Map
Figure 3-8 Conext SCP Battery Monitor Menu Map