Installation Guide

iv 975-0691-01-01 Revision B
DANGER
HAZARD OF ELECTRIC SHOCK AND FIRE
• Connect only to Safety Extra Low Voltage (SELV) circuits and power
sources.
• All wiring must be done by qualified personnel to ensure compliance with
all applicable installation codes and regulations.
• For Indoor Use Only. Install in a dry, indoor location away from direct
sunlight.
• To reduce the risk of electrical fire, replace fuses with same size, type, and
rating only.
• Do not disassemble. No user serviceable parts inside.
Failure to follow these instructions will result in death or serious injury.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Apply appropriate personal protective equipment (PPE) and follow safe
electrical work practices. See NFPA 70E or CSA Z462.
• This equipment must only be installed and serviced by qualified electrical
personnel.
• Energized from multiple sources. Before removing covers identify all
sources, de-energize, lock-out, and tag-out and wait 2 minutes for circuits
to discharge
• Always use a properly rated voltage sensing device to confirm all circuits
are de-energized.
Failure to follow these instructions will result in death or serious injury.