Manual

Installation
2–10 975-0298-01-01
To flush mount the Xantrex XW SCP with no mounting plate:
1. Peel the backing from the supplied mounting template sticker and
place it in your chosen installation location. Use the template to mark
the location for the area to be cut out.
2. Pilot-drill the mounting holes (if necessary, depending on your
mounting surface) and, using a jigsaw, cut out the hole in which the
Xantrex XW SCP will be inserted.
3. Route the Xantrex Xanbus cable(s) from other Xantrex Xanbus-
enabled devices inside the wall and through the opening.
4. Connect the Xantrex Xanbus cable(s) (and terminator if necessary)
to either network input on the back of the Xantrex XW SCP.
See Figure 2-6.
Connect a network terminator to the Xantrex XW SCP if it is the last
device at the end of a daisy chain network layout.
5. Place the unit in the opening and secure it with four #6 screws.
6. Peel off the protective plastic coating covering the screen and
indicator light.
To surface mount the Xantrex XW SCP:
1. Using the supplied template sticker as a guide, mark the locations
for two mounting screws and the access hole for the Xantrex Xanbus
cables.
2. Using a hole saw, cut out the access hole for the Xantrex Xanbus
cable(s).
3. Route the Xantrex Xanbus cable(s) from other Xantrex Xanbus-
enabled devices inside the wall and through the access hole.
4. Attach the mounting bracket with two #6 screws.
5. Connect the Xantrex Xanbus cable(s) (and terminator if necessary)
to either network input on the back of the Xantrex XW SCP.
Connect a network terminator to the Xantrex XW SCP if it is the last
device at the end of a daisy chain network layout.
6. Place the unit into the mounting bracket and secure it with four
#6 screws. See Figure 2-8.
7. Peel off the protective plastic coating covering the screen and
indicator light.
Important: To ensure communication signal quality, the network must be
terminated at each end with a terminator.