Installation Guide

3
solar.schneider-electric.com
Conext Power Distribution Panel Installation Guide
865-1015-1 | 865-1014-01
*
975-0709-01-01 Revision C
05-2015
G
Installing the Conduit Box
F
Removing the PDP Door and Faceplates
E
Wall Mounting the PDP
H
Wiring the PDP
For detailed mounting instructions, see the
Conext Conduit Box Installation Guide
Mount the Conduit Box to the bottom of the XW+ inverter/charger and secure to the wall.
Remove the PDP door
Remove the top and bottom
screws holding the door in
place
To access the wiring and breakers,
remove the upper and lower faceplates
on the PDP
1
Optional: To mount the door on the
other side of the unit, remove the top
and bottom screws holding the pins in
place and reattach on the opposite side.
Door swing out distance:
25" (650 mm)
Remove breaker
knockouts as needed
Elastic retaining
strap for storing
manuals
AC1
AC2
Event
Equalize
kW
A
Charging
!
Inverting
AC1
AC2
Event
Equalize
kW
A
Charging
!
Inverting
For detailed mounting instructions, see
the Conext XW+ Inverter/Charger
Installation Guide
Align flange with
bottom edge of
mounting plate
Secure to wall
Wall mount the Conext XW+
Before mounting the PDP, attach the Conext XW+ to the mounting plate as shown.
Wall mount the PDP
DAMAGE TO EQUIPMENT
Before releasing the full weight of the unit, make sure the PDP is seated properly on the
mounting plate.
Failure to follow these instructions can result in minor or moderate injury.
CAUTION
1
1. Align the flange on the back of the PDP with the bottom edge of the mounting
plate and lower the PDP onto the plate.
2. Secure the PDP to the wall with two #10 self-tapping screws in the bracket on
the top of the unit.
H
The PDP models 865-1015-01 come with DC battery cables, AC cables, and ground cables
factory-installed, labelled and ready for connection.
For detailed instructions and wiring diagrams, see the Conext XW+ Inverter/Charger
Installation Guide.