Conext Gateway Installation
WARNING
PHYSICAL INJURY HAZARD
Xanbus is a valid power source for the Conext Gateway. However, for the first time set-up,
using Xanbus as a power source is not recommended. the Conext Gateway clock will
override the other Xanbus devicesā clocks and could trigger unintentional time-based
events. Therefore, DO NOT connect the Conext Gateway to the Xanbus network prior to
setting up the internal clock of the Conext Gateway. Refer to "Time Setup" on pageī38 for
instructions. If Xanbus is the only source powering the Conext Gateway, after installation
verify the time settings in all devices.
Failure to follow these instructions can result in death, serious injury, or equipment
damage.
Turning Off the Conext Gateway
To turn off the Conext Gateway:
n Press the Power button according to the settings in Table 1 on page 14 or use the web
user interface to shut down the unit and turn it off.
Figure 10 Power button
Power Cycling
To power cycle the Conext Gateway:
1. Turn the Conext Gateway OFF.
a. Press and hold the Power button according to the settings in Table 1 on page
14 or use the web user interface.
b. Remove the power connections to the Conext Gateway.
2. Wait ten seconds before the next step.
3. Ensure that there is no USB thumb drive inserted in the USB Host port.
4. Turn the Conext Gateway ON.
a. Plug and connect the Conext Gateway to a power source.
Conext Gateway Conext Gateway Owner's Guide Installation
29 975-0806-01-01