Conext Gateway Installation

To change Modbus settings:
1. In the main menu bar, click Setup>Configuration.
The Configuration settings appear in the main display area.
2. Click Modbus settings.
a. Select the proper Baud rate.
b. Select the correct Parity.
c. Select the corresponding Stop bits.
3. Save the settings by clicking Apply .
Alternatively, ignore the changes by clicking Cancel.
Restarting the Conext Gateway
You are allowed to to restart, reset the configuration, or return the Conext Gateway to all
of the original factory settings remotely from the web user interface or by pressing and
holding the Power button according to the settings in Table 1 on page 14.
Figure 20 Restart Conext Gateway screen
Choose what to do in the web user interface:
1. Click Setup > Configuration > Restart Conext Gateway.
2. Click any of the action buttons depending on the kind of reset you want to perform.
l Restart Conext Gateway – will execute a soft restart of the Conext Gateway
unit. Doing so will temporarily disconnect and put all connected Xanbus
devices on Standby.
l Reset configuration – will execute a reset of Conext Gateway settings,
including passwords, network configuration, and plant setup. This action does
not affect the configuration of connected devices.
l Reset to factory settings – will execute a complete return to factory settings
Conext Gateway Conext Gateway Owner's Guide Configuration
41 975-0806-01-01